Mill Drill readout

The following is a work-in-progress. That is - the web page is incomplete but due to some serious health problems I wanted to get this idea out while I still can. With any luck I will be updating it sometime in April. I have been working on this for the past two years or so and I think I have worked all the bugs out of it (the project - not the webpage.

formatting link
Comments welcome.

Reply to
Ken Davey
Loading thread data ...

Hey Ken,

Very neat, very simple, and good pix! Thank you.

Send it as an article to Village Press maybe??

Brian Laws>The following is a work-in-progress.

Reply to
Brian Lawson

Thanks Brian. That was a thought a while back but I don't think I will have the time to polish it up to publication atandards. As it is the photos are adequate but not up to my standards and I hope to upgrade them and add a bunch more when I return home this month. Presently I am in Honduras enjoying a non-winter.

Reply to
Ken Davey

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.