new to the forum with an old nichols miller

Hi I jut picked up a Nichols Hand Mill at an auction and it turns out not to be bad. It has leadscrews on all three axis. I bought a vfd, finally figured how to wire it one of the cheap ones and it ran ok. It came with a 7/8 " arbor. I d like to know how to lubricate all the fittings and how to use the rapid feed on the x axis. Any information or manuals would be appreciated. I ve read this forum for a while but this is my first post. thanks Rock

Reply to
Loading thread data ...

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.