1. Home
  2. ⏣ General Metalworking
  3. Powcon Tig welder loose wire

Powcon Tig welder loose wire

There is loose bleu wire running from the back to the front of my
powcon 400 st.
At the back it is connected to remote plug for the torch.
Any body any idea were it should be connected?
Thanks
Pijke
Reply to
Z
Loading thread data ...
Ask these guys. They fix Powcons all the time.
formatting link
Reply to
Ernie Leimkuhler

Further Reading

  • wire feeder on Tig/stick welder

  • A friggin' monster wire feed welder followed "The Kid" home from the auction...

  • Powcon stick welder - good welds

  • Hi everyone. I used a Powcon welding machine to SMAW / stick to weld some steel...

  • PowCon 300ST part identification

  • I got a powcon 400ST for free but the wiring of the front panel is...

  • Heat Calculation In Hot Wire TIG

  • Hello to all ,I heard that Hot Wire TIG is having high deposition ratethan...

  • Wire size for welder AC supply

  • I just picked up an old Ac/DC Dayton welder (230/180 amps). The label says "Pri...

  • How to fix a loose bearing in a very big gearbox!

  • There is a very big gearbox (2000 x 3000 x 2000 mm) and one bearing atits mouth...

  • Bus Wire

  • Hi Everyone,I was at the store today pricing out wire for my HO scale power...

  • PowCon questions

  • Hi all,I'm a welding novice. I've been using my Lincoln 135 Plus for a...

  • Powcon 300ST Info

  • I am about to get a used PowCon 300ST welder. I would like to get the...

  • AirCo wire feed welder?

  • One of my shops has an AirCo wirefeed machine. I was wondering if itis worth...

  • welder wire

  • what size wire do I need from breaker box to the outlet box for a 230 ampwelder?...

  • hardening copper wire

  • Sort of stupid question about hardning copper wire. I'd like to harden some...

  • Flux Core wire

  • I have a 33lb roll of ESAB Coreshield 11 (E71T-11) and I didn't know that...

  • loose bearing

  • Got the old mower all tore down. New bearings due this evening. One of the old...

  • storing sheet metal?

  • Hi, I've got about a 4x4 piece of sheet metal for body work. I've had it since...
  • « previous thread

  • Chain hoist DONE

  • I have not done that much, but I am feeling proud. The chain hoist is now...
  • next thread »

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.