Reed Prentice lathe

All this talk about lathes reminds me that my RP has a slight problem I haven't been able to figure out. In the left-most gear ghange lever, to go to high speed, it wants to grind unless I ease the clutch in very slowly. I've pulled the gearbox cover and nothing seem out of whack. I'm afraid to pull it apart (BIG JOB) without a book. Anybody know where I can get info? We usually just don't use that gear set but it's annoying knowing it's not right. Other than that, the RP is GREAT iron.

Reply to
Tom Gardner
Loading thread data ...

Tom, What size and vintage is your Reed Prentice?

Reply to

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.