⏣ General Metalworking

30778 Threads Posts
to

OddBall Thread

I have an old Brunswick pool table that I'm restoring. The table is about a hundred years old. The pocket irons are rat...
34 comments posted 22yrs
posted by rlrsk8r at hot meal dott commi
34 comments posted 22yrs posted by rlrsk8r at hot meal dott commi

7" AMMCO Shaper

Anyone out there have one?
6 comments posted 22yrs
posted by williams
6 comments posted 22yrs posted by williams

bonding metal

Hello. I would like to bond 'zinc plated nuts or washers together for an art project, however I don't have access to, o...
25 comments posted 22yrs
posted by carer
25 comments posted 22yrs posted by carer

Stupid Question

I Have been off the tools for a while ( milling machine and Lathe ) does anyone have a list of formulars for spindle sp...
7 comments posted 22yrs
posted by Boc
7 comments posted 22yrs posted by Boc

)OT) Wbay _trying_ to spam me?

I used ebay a couple of times. I was not encouraged. Lately I have been looking for alternative places to buy goods ava...
3 comments posted 22yrs
posted by nsnsafemail
3 comments posted 22yrs posted by nsnsafemail

Lathe Electrical Issue - Thoughts please

Hello, I don't know much about wiring of electric motors etc so I thought I would post here and see what wisdom I get....
12 comments posted 22yrs
posted by user
12 comments posted 22yrs posted by user

Bison rotary table

Have been watching the rotary table discussion and decided to go for the six inch Bison rotary table that New England B...
3 comments posted 22yrs
posted by deichles
3 comments posted 22yrs posted by deichles

Ridgid pipe vise chain

Ridgid wants over $100 for a replacement chain for their BC-610 pipe vise. Is there a vendor known to sell Ridgid repla...
22 comments posted 22yrs
posted by d.doerschuk
22 comments posted 22yrs posted by d.doerschuk

Petroeum grease

Does any company on Earth still make genuine old fashioned petroleum axle grease? I go into auto parts stores in my tow...
28 comments posted 22yrs
posted by ahem
28 comments posted 22yrs posted by ahem

Pistons/rings

I'm designing and building a small 3-stage high pressure compressor for oxygen gas, to make liquid oxygen. It will take...
27 comments posted 22yrs
posted by zenadsl6186
27 comments posted 22yrs posted by zenadsl6186

3 phase welder power supply

Esab Pulse-arc 400 welder, nameplate says 60 amps at 220 3 ph, and I'm finally getting ready to fire this beast up........
9 comments posted 22yrs
posted by Precisionmachinist
9 comments posted 22yrs posted by Precisionmachinist

side play in 5C end mill sharpening fixture?

I got my 5C end mill sharpening fixture yesterday. I took it apart and cleaned all the cosmoline off, lubricated it lig...
0 comments posted 22yrs
posted by grant
0 comments posted 22yrs posted by grant

OT: Construction tools in action

http://www.ministryofsound.co.uk/media/Video/BennyBenassi/BennyBenassi_Satisfaction_300K.wmv Best regards, Spehro Pefhan...
1 comments posted 22yrs
posted by speffSNIP
1 comments posted 22yrs posted by speffSNIP