I need to adapt a Metco zinc spray gun to use standard welding hoses and hose check valves. It uses 1/8" BSP RH for oxygen and LH for acetylene. The male stubs on the gun are too close together to just make up a straight adaptor so I hope to make up two 6" hoses with 1/8" females on one end and
3/8" males on the other.
The 3/8" BSP fittings are pretty common in both LH and RH but I'm stumped at the moment where to source 1/8" BSP cone fittings in both LH and RH. The BOC / Butbro / RS components only go as small as 1/4"
Any other sources 'out there' ???????
Andrew Mawson Bromley, Kent, UK