1. Home
  2. ⚙ Model Engineering in the UK
  3. harrogate show

harrogate show

hi, i was supposed to be busy this weekend, but i now have the tim
off,,is harrogate show an all ticket venue or can i show up and pay a
the gate? im only an hour or so away from harrogate so whats the bes
day to go, sat or sun?
thanks,,,,,bil
--
blueswar
-----------------------------------------------------------------------
blueswarf's Profile:
formatting link
this thread:
formatting link

Reply to
blueswarf
Loading thread data ...
Pay at the door - £8.00
Reply to
John Blakeley
Today was good, well attended by both exhibitors and visitors, lots of interesting stuff to drool over 8-).
Greg
Reply to
Greg

Further Reading

  • Harrogate Show

  • Just a quick heads up that the Harrogate show is on next weekend Fri, Sat...

  • Bristol Show this weekend

  • The 36th Annual Bristol Model Railway Exhibition takes place this weekendat the...

  • Thresherman's show this weekend

  • The American Thresherman's show is this weekend at Pinckneyville, IL in case...

  • Bristol ME show this weekend -

  • Bristol show this weekend - anyone going?...

  • WRAM Show This Weekend!

  • As for swap shops and some good vendor participation, you can't beat the...

  • Heck, now what have I done ! TRAUB TND 350G

  • I've been casting around for a CNC lathe a bit bigger and better equipped ...

  • Bolton Exhibition This Weekend

  • Bolton and District Model Railway Club's annual model railway show is this...

  • 30th Annual Show this weekend

  • For those of you near, or not so near, the Sacramento area, the 30th Annual...

  • Have I missed the Midlands Show?

  • I haven't seen any advertising bumf for the show at Castle Donnington.Have I...

  • WRAM Show This Weekend

  • Hi M-M I won't make it this year :( every year my club charters a bus to...

  • Sheldon Lathe

  • I have to find which cabinet / desk I have my Sheldon documents. I have a L-44 a...

  • Do I have 208 or 240 volts in my apartment?

  • I just had a new circuit installed for a dryer. I was told it was 240 volt but...

  • Am I a fool to buy this mill/drill?

  • Need some advice, here...I occasionally wish I had a small mill, but can't...

  • E-Bay Lathe No 6276668512

  • If you were just unfortunate in not getting the Picasso, here is your next...
  • « previous thread

  • Chester conquest minl mill

  • evening all could someone please help with this Chester mini mill. Its about 4...
  • next thread »

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.