L111 Aluminium Plate

At an SG of 2.7 I make the weight over 26kg unless you really mean they're

They also do bulk deals on more than one parcel at a time plus they give you a discount as soon as you've used them just once. 5% I think it was for any further deliveries. Highly recommended anyway so make a note if you think it might be of use to anyone.

I thought I was being so good, having not bought a 36"x48" granite surface table (someone outbid me :).

Can you put me down for two, if you can get them, please?

Good news is that it'll avoid me having to cast the collet and chuck shelves I need to make.

Bad news' are that I won't have as much justification playing with melting stuff and that I won't have an excuse not to finish the job...

Collection of shipping would be about the same for me, so whichever would be more convenient.

regards Mark Rand RTFM

David, Thanks for that "noted".

Richard

Cannot guarantee they are that flat!

My pleasure, I will wait a few days to see if anyone else is interested if ok with you. If I buy a few I may get the price down a bit which I will pass on.

B Hell they will make expensive shelves! This is SOLID extrusion not box! or am I not quite getting it?

Richard

Put me down for 2 as well. I'm only just up the road so can drop in and pick them up ;)

OK Lester you are on the list!

Richard

Id like 1 please, would have to be delivered unless Mark is picking his up and can get one for me too, which Ill collect from his place (Would that be ok Mark?)

Email here is very old work addy, micro.turbines at google mail dot com works tho.

Dave

OK Dave you are on the list too. We will work out collection or shipping once I have them here.

Richard

I need 4 off 500x200mm. It would have needed minimum 10-12mm plate before Rotabroaching and milling the holes, I was working towards making 15mm ribbed castings due to the cost of plate. The 30mm is completely OTT, but the price is right.

"resawing" the stock to 14mm thick, then milling it clean might just be possible, but might produce something too banana shaped to clean up. I can experiment with the 120m off-cut from the first plate. If that succeeds, I've gained a tool plate, or stock for a project :-)

For Dave (or anyone else between Northampton, Rugby, Derby, Nottingham, ish). Store-forward transport is no problem.

regards Mark Rand RTFM

Richard -

One for me please - it would have to be delivered (Manchester area).

Regards, Tony

Snip

Noted

Richard

quality)

Richard,

Can you put me down for two please - they would need sending though that seems to have been covered by others!

Thanks,

AWEM

Richard,

I'd be interested in one please. Do you need to know now whether it'll need shipping or not. I may be up in the Stroud area sometime soon so could collect if convenient.

Requirements noted. We will sort out shipping or collection after I have them in my sticky hands!

Richard

Noted Richard

In article , Richard Edwards writes

Richard,

Could you please put me down for one. I also would need it delivered (SE London).

Thanks,

David

david at dlittlewood dot co dot uk

Can you put me down for two please Richard and add them to the Mark, Dave or Lester forwarding service ?

Mean to ring the suppiers today just to get a comparison price but stupid customers kept getting in the way.

John S.

Can I put my hand up for one please Richard? Would need delivery to Suffolks as well unless the network can get it here.

Peter

I tried to resist, but can you put me down for two. I am in Felixstowe=20 in Suffolk and will soon be doing trips to Bradford, Southampton and=20 most of the M25 if that goes past any collection/drop off points.