1. Home
  2. ⚙ Model Engineering in the UK
  3. machinery moving ?

machinery moving ?

has anyone any idea how much it would cost me to move a 1 ton machin
from birmingham to york ? or any suggestions as to machinery movers ?
dont fancy the idea of trailering it ! advice gratefully recieved
--
willowkevi
-----------------------------------------------------------------------
willowkevin's Profile:
formatting link
this thread:
formatting link

Reply to
willowkevin
Loading thread data ...

Further Reading

  • Any idea how much this part would cost to make?

  • Hi all,Does anyone have an idea how much this part might cost to make...

  • How much would it cost?

  • How much would it cost for a garage machinists to take a piece of 1" square rod...

  • How much cost AutoCad?

  • Hello All !!!Do You know how much cost AutoCad 2000, AutoCad 2004 ???marek

  • Moving machinery

  • I had the riggers come in and rearrange all the machine tools in the lab: two...

  • Machinery moving

  • I moved my Interact 2 mill in its intended permanent place. It was oncasters,...

  • How much does solidworks cost?

  • May sound like a dumb question, but I can't fins any retailer...

  • How much does Warley cost

  • For those going to Warley this weekend, I was wondering how much money you take...

  • Machinery moving skates

  • I'm looking at making some large machinery moving skates and need someinput....

  • KBC Tools and Machinery any good?

  • I recommend them highlyI'm not usually buying thousand dollar tooling but...

  • How much does it cost?

  • How much cost the original version of AutoCad 2000, 2002 LT?

  • Machinery moving woes

  • I live on an island. It's accessible by ferry at one end and 70 milesaway at...

  • How much does it cost?

  • To get into Solidworks. I am using AutoCad Mechanical Desktop 2000i Power Pack...

  • How much is a Henrob 2000? Has anyone used one?

  • Guys, a friend showed me a cutting torch tonight that made some real...

  • Anyone need any Hardinge CHNC 1 manuals?

  • I have a good sized box of near new manuals for Hardinge CHNC 1 lathes if anyone...

  • How much does laser cutting cost

  • Could somebody tell me the costs of laser cutting? Does it go by time, orlinear...

  • stone colours?

  • I recently bought a set of tools for a Dremel. There are four sets of mounted...
  • « previous thread

  • Finish inside a bore

  • I'm trying to machine a cylinder liner from a nice piece of 50mm cast iron bar...
  • next thread »

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.