Hi, Many thanks to Tom, Tim & Peter for the valuable information, The size I was after was 5/16" x 2" or 1 1/2"
4 required. Regards Rotty- posted
18 years ago
Hi, Many thanks to Tom, Tim & Peter for the valuable information, The size I was after was 5/16" x 2" or 1 1/2"
4 required. Regards Rotty
BSW or BSF?
Will have a dig...
Peter
-- Peter & Rita Forbes Email: snipped-for-privacy@easynet.co.uk Web:
Thats dashed good of you. Regards Rotty
Phoned a local engineering supplies outfit and they have conventional hardened square head set screws 1-1/2" & 2" for around 85p each. Not cheap but they reckon hard to get. :-(
If all else fails, airmail to the UK would be under a quid.
Tom
Many thanks for that Tom. Regards Rotty
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.