Hi to all,
I'm using Pro/E 2001, and I'm trying to create a 2-D cross-section of an assembly through my solid Pro/E file and some imported surface IGES files that my part goes around.
When I cut a cross-section in my assembly, I have the option to cut through the model and quilts, where the section through the surfaces is outlined in yellow but not cross-hatched, which is OK. In the assembly, I can view these outlines of these surfaces.
However, when I try to place these views in a 2-D drawing, the cross-section seems to remove the quilts and the cross-section outline. It only shows the solid part cross-hatched.
I'm trying not to have to turn these IGES files into solids to get this to work.
Is there any way to display these cross-sections through the quilted surfaces in 2-D drawing mode? Do I have to switch to Wildfire to get this to work?
Thanks for any replies.
Lee