'Geometry & Parameters', then click the Edit button. Select the middle tab, Center of Gravity, and fill in the offset numbers. When done, this will create a CG recognized by model analysis.
David Janes
'Geometry & Parameters', then click the Edit button. Select the middle tab, Center of Gravity, and fill in the offset numbers. When done, this will create a CG recognized by model analysis.
David Janes
to a center of mass (aka, CG)...
See, now this is a keeper. The forum's not dead yet!
Thanks, David!
Have something to add? Share your thoughts — no account required.
Ask the community — no account required