WF 2.0 - Drawing

This might be going over my head (never created a XSec that way), but if the XSec ends up in the model file, model sectioning has been moved to the View Manager in WF2.

: "CKERIDES" wrote : Created a X-section in a drawing on-the-fly by offsetting a surface. Looking : for a way to modify the dimension used to create the offset surface. This was : possible in previous versions but I don't see where to modify the X-section in : 2.0

In the part, try 'View>View Manager>Xsec'. Pick the cross section you wish to redefine then 'Edit>Redifine>Redefine', check the box labelled Section, select Done and then, pick Sketch. This will get you into sketcher where you can modify the offset geometry.

David Janes

Thanks - This worked