Wildfire 2 Pro/SHEETMETAL issues

It appears as though a Flange feature in Wildfire 2's Pro/SHEETMETAL module can not be patterned. Could someone else please verify this for me? Maybe I just overlooked something.

Also, when redefining(Edit Definition) an Unbend feature's Deform Control sketch, the sheetmetal model is displayed in a fully formed state instead of a flat state. This defeats the purpose of being able to manually sketch the flat blank region of a non-linear transition area with the adjacent, developable regions flattened out. It works just fine when you originally create your Deform Control sketch during the addition of an Unbend feature using the Unbend All option.

Anyone else hit up on the above problems yet in Wildfire 2's Pro/SHEETMETAL module?

J. Perry

Reply to
J. Perry
Loading thread data ...

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.