silvering has always been a problem which sometimes doesn.t show up until the decals are dry, no matter how much prep was taken. i find a mixture of 50% future to 50% alcohol, applied with a small brush around the edges, will remove most, if not all of it. what other methods are being used?
Prevention is usually better than cure, but your method is a good one. Pricking the decal with a needle in central areas away from edges helps too, as does slicing with a new blade along panel lines if possible. Applying suspect decals (like those overly matt ones for instance) to a local coat of Future/ Klear then pressing down with a smooth lint-free cloth warmed with hot water can also work well too.
Chek
- Change' boos' to 'bos' in address to email directly
doesn.t show up until the
a mixture of 50%
the edges, will remove
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.