Just mix it with Testors liquid cement (the kind from the glass bottle with a brush that has the viscosity of water, not the one in the black plastic bottle with the applicator tube). You can mix a little glue in or a lot, and make it as easy to work with as you wish. Also, make sure you knead the tube before you use it; sometimes it separates while it's sitting on the shelf. Mix the glue and putty in a well-ventilated room to avoid experiencing the '60s all over again.
Hi again folks. I have some Squadron Green putty and I've used it before on figure filling with good results. The thing I don't like about it is how it's like 'Bisquick' bisquit dough when you don't use enouph flour. Is there a way to make it more 'creamy' so I can apply more like you would bathroom caulk around a tub seem? I don't want to have to sand of every rivet in obvious places.
I have 'Ambroid' liquid weld. It's in the glass bottle with the viscosity of water. Will that work?
I do not know...test it first. Years ago, I "tested" such with Micro-Weld....and the result was a "sand and liquid" solution. Definitely *not* compatible.
:o)
Green Stuff will thin with lacquer thinner, and it sets up nicely. No need to use liquid glue to make it creamy.
That said, if you use thinned Green Stuff, put it on very sparingly; it will attack the styrene more than regular Green Stuff will.
--- Tontoni
Have you tried diluting it with thinner? I have some old Testors putty tubes and when the putty starts to get dry I mix in a very tiny small amount of Testors airbrush thinner and mix it somewhat like 5 minute epoxy. That seems to do the trick, and the thinner evaporates pretty quick. You may also try isopropyl alcohol - denatured for short. You can get some at the drugstore, or if you want to get fancy, you can use the Tamiya acrylic thinner which is the same thing with a different scent.
Good luck,
Ray Austin, TX ===
Regular model cement will also work; it's basically just liquid cement with some clear styrene dissolved in it to make it thicker.
Also note that the more you thin it, the more it'll shrink as it dries, so you'll have to build it up in layers, letting each layer harden completely before applying the next.
I had grown very frustrated with Sq. green putty, so on the recommendation of my local hobby shop owner I tried Tamiya putty. It's world's better, and I would recommend you trying it if you can find it somewhere.
message
well-ventilated
I tested it with Ambroid and I got similar results. Gritty grout like stuff. Note to modelers...Ambroid liquid weld and Green Squadron putty don't mix.
Have something to add? Share your thoughts — no account required.
Ask the community — no account required