Can this be done?

Can constraints be added like this?

A square say 200x200mm with a square hole say 100x100mm centrally placed. A round pin, say 10mm in diameter inserted into this share hole. Constraints added so that the pin can travel anywhere inside the 100x100mm square hole but is prevented from travelling outside the share hole.

------------------ | -------- | | | | | | | O | | | ------- | | |


------------------ | -------- | | | O| | | | | | | ------- | | |


Thanks in advance

Reply to
pete the first
Loading thread data ...

A pair of limit mates won't work?

Reply to
Dale Dunn

I tested an example with limit mates last night and it seems to work fine. That looks like the way to go.

Best Regards,

Ricky Jordan CSWP Dynetics, Inc. Huntsville, AL

check out my blog at

formatting link

Dale Dunn wrote:

Reply to
Ricky Jordan

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.