DIMENSION

HI! QUESTION FOR ALL OF YOU! I HAVE PROBLEM WITH DRAWING! WHEN I CALL DIMENSION IN DRAWING, AND ONE OF THEM I CHANGE, WHY SOLID DONT CHANGE DIMENSION IN PART IN THE SAME TIME, I MEAN, WHY SOLID DONT OFFER ME A OPTION REBUILD!! HERE I MEAN , WHY I DONT HAVE CONECTION BETWEEN DRAWING AND PART!! PLEASE HELP ME! THANK YOU VERY MUCH!!!!!!!!!

Reply to
H.Rapic
Loading thread data ...

You can only do this if you imported the dimension from the model using Insert Model Items. I believe threre is an option that needs to be checked durring installation too.

Reply to
Corey Scheich

In addition, I believe you must have installed Solidworks to allow drawing changes to change the model. If no, you'll need to re-install Solidworks and check this option.

Reply to
Tony

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.