Hi,
I had something strange happen...
Had a custom property (revision - in a part) as a lower case "a" as a mistake...
Made a drawing and noticed it was a lower case "a"...
Went back to part and changed it to an uppercase "A"...
The drawing still showed a lower case "a", even after saves and rebuilds?
Went back to part, changed rev to a "B", back to drawing now is a upper case "B", back to part changed to a rev "A", back to drawing and it is correct...
It was acting as though it would only change the case of the rev property, if it was a different letter?
2007 sp3.1
Aron