1. Home
  2. Solidworks CAD Design software
  3. Hole table bug in 2004

Hole table bug in 2004

Hole tables are a great tool for parts with high hole density. But it
has a serious and potentially costly bug in 2004-Rel 0. The table
occasionally reports incorrect hole dimension values. Very
occasionally, but I have a drawing that repeats the error. This has
been reported and acknowledged by SW.
Cheers bob
Reply to
rab
Loading thread data ...
I was just notified that SW has identified and fixed this problem and hole tables should work correctly in the next SP.
Cheers bob
Reply to
rab

Further Reading

  • Hole Tables

  • Hi.Is there a way of getting SW05 to work out hole tables properly? I use a lot...

  • Hole tables

  • I have a sheet metal panel with a hole table.This hole table insists on...

  • One hole straps - hole up or hole down?

  • When running EMT on a wall parallel to the floor and using one hole strapsfor...

  • Hole tables

  • Anyone know how to do a hole table using a detail view in drawings. Ican't...

  • Hole tables

  • Anyone used hole tables in WF? I remember them as being difficult,...

  • Hole table

  • I'm using SW2007 sp5 and my issue is: I've been using sp5 for 5-6months...

  • Thin kerf hole saw?

  • I want to cut round clean-out doors in my birdhouses and wishthere was a hole...

  • Enlarging anvil hardie hole ?

  • OK heres a nice problem !I have a heap of stakes for use on an anvil with a 1...

  • Hole Table Question

  • Anyone know how to setup a hole table as follows:Insert a hole table with TAG, ...

  • Using Hole table

  • I have a problem using hole table. I did a big part where on one face I have...

  • hole fill - romex runs

  • I'm pulling 14-2, 14-3, and 12-2 perpendicular to I-joists. Cannotsee any...

  • .020" dia hole drilling

  • You need a hole popper. 5 seconds a hole.

  • pin/hole strength calculation in telescoping legs?

  • I'm building a small rolling gantry with telescoping legs. Each leg should...

  • 2004 Hole Wizard

  • Is this a "Bug" or was there a change to the standards?Can anybody verify this...

  • Etymological question -- "waller" a hole

  • The sons of the family mechanic talked about "wallering a hole", in the sense...

  • Nvidia quadro FX 1000 or 2000 experience?

  • Not that money is burning a hole in my pocket... but I am thinking of upgrading...
  • « previous thread

  • "Forklift type" chair model

  • Has anyone modeled a "forklift type" chair? I am looking for a native SolidWorks...
  • next thread »

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.