how to assembly part (solid edge)?

I have to assembly some parts with Solid edge, but I can't place these parts
where I want. I think that i should use the "match coordinate system"
command but i don't know how!
I have to put a sphere inside an empty prism; between the two parts must not
be any contact; probably i have to allign coordinate planes...
How is it possible?
Thank you.
Reply to
Daniele
Loading thread data ...
This is the SolidWorks newsgroup. For SolidEdge assistance log on to their newsgroup.
Daniele wrote:
Reply to
P.

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.