1. Home
  2. Solidworks CAD Design software
  3. Looking for a solidworks help.

Looking for a solidworks help.

G'day all...

I'm working on a modelling project which requires some rapid prototyping to be done. I've attempted to use 3dsMax but I've little (almost no) CAD experience at all.

What I'm looking at having done is basically a three sided box with the sides made up of compound curves on the outside, square cavities inside and doors & windows along the side. The dimensions of which are

35.04mm (w) x 264.36mm (l) x 33mm (h)

I've attempted to use MeshCAM to convert a black & white cross section of what is required into an STL file, but the local rapid prototyping service advised me the file couldn't be read.

Is there anyone out there who would be willing to take this on? It's probaly a small job that shouldn't take an experinced person more than a couple of hours but I am willing to pay for your time of course.

Regards Dave.

Reply to
prometheus_au
Loading thread data ...

Tried to send you an e-mail Dave, but it bounced-back to me. I may be able to help with your project if you could send a little more information about what you want modeled up.

Shoot me an e-mail.

Reply to
Fye

Go to

formatting link
you can contact me there and we can go from there

Ben

prometheus snipped-for-privacy@excite.com.au wrote:

Reply to
Ben Eadie

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.