I just loaded Outlook on this new computer, and it is only showing posts from the 8th on, so I don't know if this has been covered.
How do I get the Rev Table anchor on an existing drawing?
____________________ Todd Bennett Mechanical Designer
CELERITY GROUP, INC snipped-for-privacy@celerity.net
I figured out a work around to add anchors (assuming there isn't a proper way).
To old templates:
1) Open a blank drawing using your template. 2) Add a sheet using the same template. 3) Delete the first sheet.To existing drawings:
1) Open an existing drawing. 2) Add sheets using the same templates as the relative sheet. 3) Copy the views to the new sheet. 4) Replace your BOM, Rev Block, etc.____________________ Todd Bennett Mechanical Designer
CELERITY GROUP, INC snipped-for-privacy@celerity.net
Have something to add? Share your thoughts — no account required.
Ask the community — no account required