Sketch Pattern Bug, I hope, this needs to be fixed.

Sketch Pattern works fine... only if your sketch with the reference
points doesn't contain external relations to other parts. As soon as
you delete any external relations in the sketch, its ok. I have an
assembly and tried to mark cuts with sketch points in a part with
another part but couldn't get the Sketch Pattern to work until I
deleted the points external references. Why?
Reply to
Joe Sloppy
Loading thread data ...
Nevermind this, I recreated everything and it works OK, now I just need to figure out what I did before that screwed me up.
Reply to
Joe Sloppy

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.