SolidWorks 2007 SketchBlockInstance API defect

SolidWorks 2007 use a new API SketchBlockInstance to Control the Block. I had use SolidWorks 2006 API, in SW2006: Model2-->View-->Block But in SolidWorks 2007 API. it is: Model2-->SketchManager-->Block

I can't find any way to find which sheet the block is on. Any Suggestions? Thanks a lot.


Reply to
Loading thread data ...

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.