Is there a way to drive a Part dimension in a Design Table from an Assembly equation?
Example - say length of part1=length of part2 at the assembly level [driven by equation]. Part1 is a standard shaped part, used multiple times in the assembly and is driven by a design table for other dimensions [like width and thickness].
Or conversely, is there a way to uniquely name configurations at the assembly level [configurations driven by a design table] and then pass the $config parameter as well as the dimension via the equation editor at the assembly level?
Example - as above but use the $config in the equation editor somehow to reference the dimension of the appropriate config in a design table.
Thanks, MMW
KurtSchneider NH, USA