My HO layout consists of a few Atlas 542 and 543 snap switched. They currently have Caboose Industry HO operating ground throws. My layout has 3 inches of foam board. I would like some sugestions on what would be the best way to power the switches for remote control. BTW: I am using DCC to run my layout and the switches do not have to be DCC based remote throws.
Thanks,
Kurt
I like the Tortoise motors. You will need to use a longer and slightly heavier gauge wire, but it will work very well.
Yes, I too have used Tortises through 4" of foam and 1/2" of plywood. Just need a longer and stiffer wire.
Tim.
kurt x wrote:
Tim
What gauge wire did you use to go through the 4 1/2 inch of material.
Kurt
I use 0.047 music wire. You have to drill out the hole for the wire on the switch machine to accomodate the larger diameter wire.
Steve B.
Have something to add? Share your thoughts — no account required.
Ask the community — no account required