Anybody got something like this for sale which they could bring along?
formatting link
Don't want complete chaff cutter, mill or whatever, just a sturdy and stable iron 'table' upon which to mount replica Robinson hot air engine.NHH
Enstone - wanted
Nov 11, 2009
5 Replies
Sorry, Nick, can't help.
I shall be there early (8 ish) as I am going on to Kent afterwards. I expect to be away by (say) 10.30.
My usual assistance with directions from the M5.
Enstone Airfield - OX7 4NP
Leave M5 at J 11A.
A417. SO A436.
Junction of A417/A429, TL Bourton on the Water.
A429 to Stow on the Wold. TR A436
Junction A436/A44, TR A44 - Chipping Norton.
by-pass Chipping Norton continuing on the A44.
2.9 miles after the traffic lights to the east of Chipping Norton, you enter the 30mph limit signifying the start of Enstone village.300m after the 30 limit signs turn left, signposted Church Enstone and Bicester.
Continue round the back of Enstone village, through Church Enstone, across the B4022/B4030 junction.
The entrance to the airfield is 0.75 mile on your left from this point. Look out for the "Vintage Sale" siogns as you get close.
Regards,
Kim Siddorn
kimsiddorn wrote (snip):
Should be there by 9 ish, but if I am late or don't catch up with you for any reason, could you leave Enfield handle with Martin (I'm assuming you'll be there Martin?)
NHH
Nick - If Martin's not around I will be there from 0730 ish all being well.
Regards
Dan
Nick/Kim,
I shall, bring a mug there might be tea in the offing :-))
Of course Nick. I'll be carrying it about with me should we meet - look for the big bloke with a pronounced list!
Regards,
Kim Siddorn
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required