Petter M Govenor Assembly

Hi
I recently purchased a 1920 5 HP Petter M. It was missing the bracket
that holds the govenor onto the side of the crankcase. I promptly
purchased one making clear the type of Petter M it is. When i came to
fit this bracket though it was too small and the whole unit would
actually fit between the two studs that are suppose to hold it on. On
contacting the seller he said that it was definatly off a 5HP M type.
Could the size of this unit difer between earlier and later models or
is it a case of the wool being pulled over my eyes?
Reply to
George
Loading thread data ...

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.