Hi guys I?m working on a 67' ChevII and I?m doing a custom 3 link on it. Im replacing the frame rails and adding a cross member to mount the links to. Now I have the x member and the frame rails tacked in. I was looking at the whole deal and it looks like I can drop the whole pig out. My question is: now that I have the rear rails and x member tacked and measured out for the car, can I remove the whole unit and complete it out of the car? Or should I just weld it up in the car? Some of the parts I need to get to and weld are very hard to reach, this would make it alot easier as you can imagin. Request assistance please
Barbara
-------------------------------------
##-----------------------------------------------## Delivered via
formatting link
Forums Web and RSS access to your favorite newsgroup - sci.engr.joining.welding - 10233 messages and counting! ##-----------------------------------------------##