I purchased the trainer attachment for the blade cp, the four little yellow/orange balls. Problem is, for the life of me, I cannot figure our how to attach these since there are no directions. Help. Thanks!
Blade CP Trainer attachment
Mar 24, 2006
3 Replies
I don't have one but I think you just rubber band them on the skids in a cross. You do have two sticks? mk
formatting link
>
It's kinda hard to explain in text. You have to clip the four holders onto the landing skids at each upright then slide the rods with the balls through each clip and into the center hub. It looks a bit weird until you get a couple of them on there then you should see how it goes.
| I purchased the trainer attachment for the blade cp, the four little | yellow/orange balls. Problem is, for the life of me, I cannot figure our | how to attach these since there are no directions. Help. Thanks!
formatting link
gives the page on the Blade CP, but I don't see any documentation.
The Blade CX page at
formatting link
does have documentation, and part of it tells how to put the training gear on -- and it'll be the same on the CX as on the CP. So just read that.
A direct link to the CX documentation is here --
formatting link
Page
18-20 tells about the training gear.
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required