Blocks, Base Point, attachment point?

The built-in revision table doesn't quite work for me. I'm going to create
blocks, one for each revision line, and add as needed.
I had no trouble creating the block, and specifying the Base point.
However, I can't figure out how to specify an attachment point (the point on
each revision line, or block, that the next line (or block) will attach to).
How do I do that/can I do that? If for some reason it's not possible, is
there another way to do revisions without the revision table? Thanks...
Brian
Reply to
Brian
Loading thread data ...
I know it can be done, because I did it once. I just don't remember how...
Reply to
Dale Dunn

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.