Anyone out there with one of these? I have a customer with 5x with this control, it has quirk in that wants a F code before it will run. Even with a positioning move?
Is there a control setting or something missing" Do just throw in a F##.## for the hell of it?
Fred
That's fairly standard behavior for any control that defaults to G1 mode at reset (or, for the 950, a colon block).
You can program a G0 to switch to rapid, then no F word is required.
Positioning and contouring are separate from rapid and feed mode.
HTH, SteveA
Have something to add? Share your thoughts — no account required.
Ask the community — no account required