Mastercam X post settings

I need the post to output three places to the right of the decimal in inches. I changed the tolerances to 0.001 and checked truncate in the
control definitions. It outputs three places in G2 & G3 but G1 is four places.
Is there another control somewhere?
Thanks, Dave
Add pictures here
<% if( /^image/.test(type) ){ %>
<% } %>
<%-name%>
Add image file
Upload

Polytechforum.com is a website by engineers for engineers. It is not affiliated with any of manufacturers or vendors discussed here. All logos and trade names are the property of their respective owners.