OpenGL vs. GDI - Mastercam

Hello All,
I just installed X6 and the default is OpenGL. I create geometry and I can't freeking see it until I switch to GDI? What gives with this? Is it my graphics
Is there a hot key combo that I can use to switch between the two. It is a pain in the ass to go into setting and change it back and forth.
Add pictures here
<% if( /^image/.test(type) ){ %>
<% } %>
Add image file
Upload is a website by engineers for engineers. It is not affiliated with any of manufacturers or vendors discussed here. All logos and trade names are the property of their respective owners.