How we can interface any NC di/do on the back of the fanuc oimc just like coolant switch.
- any parameter to switch
- any external system
- nc programming
PMC interface
Mar 02, 2008
2 Replies
sanjeev wrote in news:5da3b1ff-9b3a-4ddf-b622- snipped-for-privacy@s8g2000prg.googlegroups.com:
If there are unused M codes already programmed and active in the PMC, you can use those. Otherwise, you need the FAPT PMC programming software to create them.
hmm in same case i can use something defined for reinshaw 's system and other such sensors good but i wanted to edit pmc right on the machine without additional software or without re write the rom/ladder
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required