Feed Thru breakers

I need a I.T.E. 3 pole feed thru breaker, minimum of 30 amps, and I went to the local electrical supply and the said they don't really make them anymore so he came up with a concoction of a breaker with lugs on one end and tabs on the other with lugs that slide over the tabs and some mounting bracket and after all that it was going to be about $150.00 and I don't want to spend that much. I have tried looking on the internet without much luck. If anybody can help me out please let me know. Thanks in advance.

Reply to
321zyx
Loading thread data ...

here in ontario i use a couple of places that salvage electrical equipment one is

formatting link
was also GE for a while and now check siemens

Reply to
PCK

Sounds like you need a MCB (Molded Case Circuit Breaker). The have lugs on both line and load ends All breaker manufacturers make them.

formatting link
ITE was also GE for a while and now check siemens

>
Reply to
Paul S.

If your looking for lugs on the line and load then all you need is look at the 100 amp frame size, ( what ever that is in ITE )

formatting link
This page shows a picture of a breaker rated at 240 volts You could put lugs on one side.

If your dealing with greater than 240 v then plan on spending a lot of money on a new breaker.

Reply to
SQLit

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.