Does anybody have the pin sizes right off hand for Master No. 3 padlocks?
0-6
TIA,
goma
- posted 18 years ago
Master No. 3 lower pins
Loading thread data ...
- posted 18 years ago
Be aware that the diameter of the Master padlock pins are smaller than
standard cylinder pins. My Master pin kits do not have the actual pin sizes
on the kits like most normal pin kits. I miked them so this is very close.
0 .112
1 .127
2 .142
3 .157
4 .173
5 .188
6 .205
7 .220
Ron, Ron's Lock & Key
- posted 18 years ago
Thanks again Ron-G'day.
goma.
goma.
Site Timeline
-
master key systems
- hey guys a quick query... Im looking for a new master key system away from the...
- next in
🔒 Lockmithing and Lockpicking Discussions
-
Odd Request To Everyone.
- Hey Guys & Gals, I have been looking to find one of these for an escape show I...
- previous in
🔒 Lockmithing and Lockpicking Discussions
-
Slaymaker combination lock
- I have very old slaymaker combination lock was bought 1977 , still is in good...
- last updated in
🔒 Lockmithing and Lockpicking Discussions
-
What type of lock would use this key?
- Hi, At the link below is a pic of a key that belonged to my late father. I'm...
- last posted in
🔒 Lockmithing and Lockpicking Discussions
-
laser do betonu
- Po weekendzie z wiertarkÄ… ... nie ma jakiegos laserowego dziurkacza do betonu?...
- site's last updated in
Engineering Science (Polish)
-
laser do betonu
- Po weekendzie z wiertarkÄ… ... nie ma jakiegos laserowego dziurkacza do betonu?...
- site's newest in
Engineering Science (Polish)