1. Home
  2. ⚙ Mechanical Engineering
  3. Compatibility SolidWorks - Unigraphics

Compatibility SolidWorks - Unigraphics

Hey!
I'm in a pinch! I need to know how well works the translation of
solids prepared in SolidWorks to Unigraphics and vice versa. If anyone
could provide me with such information, I would be most grateful!
Please send info to:
snipped-for-privacy@o2.pl
Reply to
Pyriel
Loading thread data ...
You should get good results using "Parasolid" translation in both directions. I would suggest a slightly older version, such as Parasolid 10.
Keep in mind that the translated parts will be "dumb" solid models. You will have the geometry, but none of the parametric history from either CAD system.
AW
Reply to
Art Woodbury

Site Timeline

Related

  • Unigraphics Compatibility

  • I am involved in a project where my deliverable is a set of Unigraphics 3-D...

  • Solidworks to Unigraphics

  • Does anyone out there have any recent experience exporting SolidworksModels or...

  • Unigraphics

  • Hello everyone!Can you tell me please where I can find Unigraphics to...

  • Unigraphics

  • Hello everyone!Can you tell me please where I can find Unigraphics to...

  • Compatibility

  • One the subjects that we on the group never got round to discussing was...

  • Compatibility charts...

  • Why can't I ever find these at PTC's website? Can anyone direct me...

  • Acetylene vs Propane - hose and fittings compatibility ?

  • What are the rules for compatibility with acetylene and propane hoses?Also for...

  • Coolant compatibility...

  • Awl --How do you know if two coolants are incompatible? Is there a...

  • SOLIDWORKS compatibility with Virtual PC 7.0... yeah SOLIDWORKS on an APPLE....

  • Ok so the long and short of it is that I know a guy who just bought a15 inch G4...

  • Re: Paint compatibility

  • It'd help if we knew what you have in mind.Compatibility with what, other...

  • Opening Unigraphics Files

  • Anyone else having problems opening large (280 meg) UG files in SolidWorks?...

  • Airco 750 handle tip and torch size compatibility

  • compatibility-53458-.htm I did a little checking and your model seems to be a...

  • FINISHING COMPATIBILITY CHART

  • Here's a transcription of that chart I mentioned, detailing thecompatibility...

  • Unigraphics NX2 - What up?

  • Has anyone heard anything good or bad about Unigraphics NX2? We had themcome...

  • Anybody running unigraphics nx5?

  • I downloaded it, and some good training modules. One thing I noticed, my 3 gig...

  • SolidWorks API - MakeStyledCurves2

  • SolidWorks API - MakeStyledCurves2This is the API command to fit a spline, but...

  • Alclad compatibility with Xtracolour ?

  • Hi,I know the Alclad instructions mention that for some shades, you have to use...

  • SolidWorks Sucks...

  • SolidWorks got where it is because it offered better value in the late90s up to...

  • Wacom Tablet and Solidworks

  • I primarily use Solidworks for product design and have always used amouse with a...

  • where download solidworks 2003

  • where can i download solidworks 2003 please ??(i'm french !! ;) )thank you

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.