1. Home
  2. ⏣ General Metalworking
  3. 3/4-12 ASA Shank Chucks?

3/4-12 ASA Shank Chucks?

Anyone know where I can find a 3/4-12 ASA shanked chuck?

Regards, Joe Agro, Jr. (800) 871-5022

01.908.542.0244 Automatic / Pneumatic Drills:
formatting link
Spindle Drills:
formatting link
Tapping:
formatting link
Site:
formatting link
formatting link
V8013-R
Reply to
Joe AutoDrill
Loading thread data ...

I believe that ASA=3DAmerican Standards Assoc. =96 the precursor to ANSI (American National Standards Institute). My guess is that the ASA =BE-12 thread should be a =93standard=94 =BE 12UN thread as listed in your Machinery Handbook. Dremel made a small woodworking lathe (Moto Lathe) with this mount and the plastic nose piece on their Dremel tool is supposed to be that size. You can buy a chuck adapter:

formatting link
, but you can probably make one faster and cheaper.

Reply to
Denis G.

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.