#3 Morse Taper Hand Drill?!?

Joe AutoDrill · 2010-07-13T15:24:27+00:00

I'm in the industrial drilling industry and struggling to understand why would someone want a MT3 equipped, electrically powered hand drill... guess there are indeed legitimate needs for it, but... Well... I can only pray I never have that need!Talk about a wrist twister if you're not smart.Regards,Joe Agro, Jr.(800) 871-502201.908.542.0244Automatic / Pneumatic Drills: Spindle Drills: Tapping: Site:

Jul 13, 2010 Last reply: 4 years ago 23 Replies

Rate this thread:

Gerald Miller 16 years ago

The auger bit or the drill motor? My drill motor cost me $2, but I did replace the power cord, after I peeled off the 11 patches of duct tape. Gerry :-)} London, Canada

Vote

John Husvar 16 years ago

The auger drill. The drill motor should have been smelted at birth.

I'm a bit surprised. The prices for them haven't risen all that much, ~$15-25 apiece. Still, I don't suppose ruining one would endear one to his boss. It didn't for me anyway.:)

Vote

Bret 4 years ago

replying to Joe AutoDrill, Bret wrote: Most likely they have Morse tapered drill bits and would rather use them instead of buying new 1/2â shanked bits.

Vote