I have a 1970's Excello XLO vertical Mill I want to sell. It has an NC tape driver and all the stepper motors. I purchased it at an auction with a friend of mine about 8 years ago. It is a factory NC mill, but based on a standard manual vertical mill. There was a electronic problem with the Mill so the shop owner had started to convert back to a manual mill, but never completed so the mill sat unused for many years. So this could either be reassembled back to the NC mill or would need a couple of handles to make back into a very good vertical mill.
3 phase 220 volts, 9 x 46" table. Very little wear on the mill.
email me at snipped-for-privacy@hotmail.com if you have any questions. Asking $2,200 as this is what we paid, but will to consider other offers