Need source: Alum/Steel tray

- G
- gari
  
  Contact options for registered users
posted
19 years ago

Fri, Aug 27, 2004 4:20 AM

7"(h) x 9.5"(w) x 1.3 deep. Any radius in the corners would need to be outside these dims.

Could be a little higher, no more than .5", longer, up to 1", and could trim to depth.

thanks

gary

Loading thread data ...

- K
- Karen Story
  
  Contact options for registered users
Vote on answer
posted
19 years ago

Fri, Aug 27, 2004 5:15 AM

- K
- Keith Marshall
  
  Contact options for registered users
Vote on answer
posted
19 years ago

Fri, Aug 27, 2004 3:27 PM

How about one of these?

formatting link

Best Regards, Keith Marshall snipped-for-privacy@progressivelogic.com

"Even if you are on the right track, you'll get run over if you just sit there." - Will Rogers (1879-1935).

XML Sitemap
Terms of Service
Privacy Policy
Contact

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.