Hello Folks - OT post here because I really respect the members here and their knowledge about both motors and rebuilding machines:
I was ripping wood yesterday with my 8 year old Ryobi BT 3000 table saw and the motor started pouring out blue smoke - not to mention stinking to high heavan. It has a custom motor that runs a short ribbed belt to the actual shaft that turns the 10" saw blade. The current motor is encased in a plastic housing that makes it almost look like a large 1/2" router mounted perpendicularly to the blade housing.
I'm thinking that I have three options: Order a replacement motor from Ryobi, track down a used/rebuilt unit, or replace the motor with a generic unit and fab the necessary mounts to fit the new motor to the blade housing.
Here's my question - what type of motor would you recommend if I go that route? I'd like something in the 120V 10-15amp range sufficient to run cooly with a 10" blade.
Any and all suggestions are welcome.
Sincerely,
--George