Will the AXA size Aloris toolpost work on an imported 9"x20" lathe? It's an Enco, if that makes a difference.
If not, what is recommended?
Thanks in advance,
Stan
ps: I didn't buy the lathe - it is at my office!
Will the AXA size Aloris toolpost work on an imported 9"x20" lathe? It's an Enco, if that makes a difference.
If not, what is recommended?
Thanks in advance,
Stan
ps: I didn't buy the lathe - it is at my office!
I had the Enco and used the AXA sized Phase II. It was a perfect fit.
Have something to add? Share your thoughts — no account required.
Ask the community — no account required