What industrial air quick connects

Ignoramus29973 · 2012-06-07T22:45:27+00:00

We have finally hooked up our air compressor to the existing airpiping in my factory. The bad news is that the existing connectors are either missing, orold and leaking. I would like to replace them all with something new. I would need, say, a dozen of them and I wanted to get something thatcan last me for a while. I prefer "industrial type" connectors, where should I buy them, thanksi

Jun 07, 2012 22 Replies

Rate this thread:

Tom Gardner 14 years ago

It only takes 10 hp to run the shop. Actually, the 7.5 hp Hydrovane will just carry it. Any time we have greater than a 50% duty cycle we get very serious about finding the issue.

Vote

Ignoramus6827 14 years ago

This is nice. We also have a 10HP Quincy QR-25. We just about finished to set up compressed air. We added an aftercooler from a scrapped tow behind compressor. We put it between the compressor and the air dryer, to improve efficiency of the dryer and to reduce costs. I had a panel of 110v fans that we put on that aftercooler.

Vote