1. Home
  2. ⏣ General Metalworking
  3. WTD Univise Unihead

WTD Univise Unihead

If anyone has one they'd care to sell. Email me directly. I see there is someone on ePay selling knock offs of the Univise.... I aquired a Delta Milwaukee Toolmaker Grinder, would like to find some of the accessories. Marty

Reply to
Marty Escarcega
Loading thread data ...

Is it Jeff?

formatting link
I looked over all the stuff at his place and didn't see anything of low quality. The Univise seemed decent but I bought two more $50 Multifix lathe tool holders instead. I use toolmakers vises and angle blocks to grind tool bit angles.

I have the Toolmaker center-grinding swivel table and have to say it reminds me more of Shopsmith than Cincinnati. The swivel adjustment screws are too close to the pivot point for really precise angle settings, although it sharpens taps well.

Jim Wilkins

Reply to
Jim Wilkins

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.