⏣ General Metalworking

30777 Threads Posts
to

Servicing an old Lincoln Idealarc 250 ?

You win some and you lose some. On eBay, I scored an old AC/DC Idealarc 250 (the kind with the round corners, not the c...
2 comments posted 21yrs
posted by a
2 comments posted 21yrs posted by a

Metalworking lathe problem

My husband just got 12"X36" metalworking lathe, Central Machinery #33274. The handbook is not that great and he cannot...
6 comments posted 21yrs
posted by cmitsch
6 comments posted 21yrs posted by cmitsch

Crush Washers for Oil Pan - Substitutes?

My Subaru's oil drain plug requires a crush washer to seal. I tried reusing the old washer, but oil dripped out and I w...
8 comments posted 21yrs
posted by GeoLane_NOSPAM_
8 comments posted 21yrs posted by GeoLane_NOSPAM_

Mill Drawbar Questions

I recently acquired a used Rong-Fu RF-30 Mill-Drill (unfortunately, no room for a full-sized mill). The drawbar that ca...
6 comments posted 21yrs
posted by no-spam
6 comments posted 21yrs posted by no-spam

tool post size

What size QC tool post fits Colchester/ Clausing 15" 8000 series (Triumph 2000)? Is it practical to cut a CA post & tool...
3 comments posted 21yrs
posted by mjak
3 comments posted 21yrs posted by mjak

vfd question

I am in the market for a VFD. The motor it is driving is a 10HP Baldor 3 phase. I have single phase power (100amp servi...
13 comments posted 21yrs
posted by rbce2003
13 comments posted 21yrs posted by rbce2003

Birthday Gloat

OK, I treated myself to a ReadyWelder II for my birthday, which is coming up. Got it yesterday. I ordered the 10000 ADP...
1 comments posted 21yrs
posted by keillorp135
1 comments posted 21yrs posted by keillorp135

OT: spotting scope

I was at the shooting range last weekend. I was sighting in a new scope. I was using a borrowed Bushnell 60mm 60x spott...
28 comments posted 21yrs
posted by cas
28 comments posted 21yrs posted by cas

quick question on o rings

I had the radiator repaired on this 96 chevy. It has an oil cooler built into the radiator. O noticed the lines had o r...
2 comments posted 21yrs
posted by stryped
2 comments posted 21yrs posted by stryped

Copper or Bronze bar?

Looking at doing a concrete slab and want to add either copper or bronze bar to create the concrete separations necessa...
8 comments posted 21yrs
posted by NoSpam
8 comments posted 21yrs posted by NoSpam

motor on bicycle

because of the high proce of gas, would putting a motor on a bicycle be practicle to get to work a few days a week? I l...
63 comments posted 21yrs
posted by stryped
63 comments posted 21yrs posted by stryped