⏣ General Metalworking

30778 Threads Posts
to

Heat treating steel

Could anyone in this newsgroup tell me where I can get a book on heat treating the different types of steel. I would li...
2 comments posted 22yrs
posted by jamrelliot
2 comments posted 22yrs posted by jamrelliot

Cutting T-slots

I've never done this and wonder if the cutter should be the full width or should you make multiple passes with a narrow...
2 comments posted 22yrs
posted by rhull
2 comments posted 22yrs posted by rhull

Painting Aluminum

I'm building a project out of not-anodized aluminum. I want to paint it, preferably with spray paint. It is mostly made...
1 comments posted 22yrs
posted by noemail
1 comments posted 22yrs posted by noemail

Metal lathes

I would like to try my hand with a metal lathe. I'm looking at a Jet model BD-920n, the grizzly g4000, & a $799 lathe a...
6 comments posted 22yrs
posted by jb5
6 comments posted 22yrs posted by jb5

Grizzley Sheet Metal Equipment Any Good?

I've been looking for some sheet metal equipment (shear, pan brake, etc.) for some time now and there isn't any to be f...
2 comments posted 22yrs
posted by dpidwerbecki
2 comments posted 22yrs posted by dpidwerbecki

Heat Treating Wedges?

I need to pull some beqarings off a shaft. Not having a bearing puller, I was thinking I'd machine a couple of slotted...
6 comments posted 22yrs
posted by n5kzw
6 comments posted 22yrs posted by n5kzw

Electronics guy in Southern California

Hello everyone, I am looking for a electronics person to help me in the repair of Sokki and Autometronics digital reado...
2 comments posted 22yrs
posted by lmsc
2 comments posted 22yrs posted by lmsc

Barber Coleman 6-16 hobber manual?

The title says it all... does anyone have a manual for this machine? Mark
0 comments posted 22yrs
posted by mark
0 comments posted 22yrs posted by mark

Drill bits

Is there a logical reason for drill bits all being different lengths? When I want to drill different sized holes on the...
14 comments posted 22yrs
posted by noemail
14 comments posted 22yrs posted by noemail

Injection mold question

If one were to extend the length of the top clamping plate, say 1" on each end, and extend the ejector plate the same,...
6 comments posted 22yrs
posted by larsen-tools
6 comments posted 22yrs posted by larsen-tools

OT: Lose the eyeglass fog

Couple days ago, I finally got fed up with the scratches on *both sides* of my eyeglasses. Objects appeared to be in a...
7 comments posted 22yrs
posted by Winston
7 comments posted 22yrs posted by Winston

Repairing plastic fuel tank

I have a small outboard motor with a split gas tank. The tank holds less than a quart. I've repaired this by welding a...
7 comments posted 22yrs
posted by steve.withnell
7 comments posted 22yrs posted by steve.withnell

Require Custom Fabrication

Hello Folks (Again!) As some of you may remember, I am looking to have the following built: http://www.newlinemagic.com...
0 comments posted 22yrs
posted by magician
0 comments posted 22yrs posted by magician