⏣ General Metalworking

30778 Threads Posts
to

need cables for old Adept Ultraone robot

I bought an old Adept Ultraone robot on ebay and am trying to bring it to life, but need a little help. The 3 cables go...
2 comments posted 22yrs
posted by wddanielson
2 comments posted 22yrs posted by wddanielson

FA---ADD**** Fanuc 6M Model B manuals

I have on EBAY (2) Fanuc 6M Model B manuals http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=3826300985 Cheap if you n...
0 comments posted 22yrs
posted by pete
0 comments posted 22yrs posted by pete

FA: 4 Micrometers

http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&category=26260&item=3826336434
0 comments posted 22yrs
posted by Emurpus
0 comments posted 22yrs posted by Emurpus

Spindle Getting Extremely Hot on Lathe

I have a Sheldon WM56P 13x36 Variable Speed Lathe. I noticed when I was cutting some extremely tough cast iron in back...
2 comments posted 22yrs
posted by Sierevello
2 comments posted 22yrs posted by Sierevello

WTB 7/8-18 LH tap

Anyone know of a source? 7/8-18 RH is readily available, but I'll be darned if I can find a listing on the LH version. T...
2 comments posted 22yrs
posted by barrsoom
2 comments posted 22yrs posted by barrsoom

Dual axis pivot?

Like I don't have enough on my plate, I have been volunteered to build a rather large Foucault Pendulum. The bob is goi...
19 comments posted 22yrs
posted by gashmore3
19 comments posted 22yrs posted by gashmore3

Used Case 580E evaluation

I posted this in alt.construction, but there were no replies. Please no flames for cross-posting. I have been casually...
9 comments posted 22yrs
posted by rleonard
9 comments posted 22yrs posted by rleonard

Machinery/mechanicaly inspired furniture

Hello, Someone else posted a link to this group of pictures in an earlier thread. I was browsing through them and came...
3 comments posted 22yrs
posted by kmeloy
3 comments posted 22yrs posted by kmeloy

AirCompressor Check List?

greets folks, have been shopping for a new (larger) air compressor for the shop and i think i found one. will have a lo...
4 comments posted 22yrs
posted by tony
4 comments posted 22yrs posted by tony

Routing Hard Aluminum

I thought I sent this once before, but can't find my question. Has anyone had any experience with trying to rout aluminu...
6 comments posted 22yrs
posted by chanlesa
6 comments posted 22yrs posted by chanlesa

Rust-proof steel finish

I'm a first-time poster here, so go easy on me. I'm getting ready to fabricate some steel hardware for a timber frame h...
14 comments posted 22yrs
posted by richard.k.johnson
14 comments posted 22yrs posted by richard.k.johnson

rockwell horizontal mill grease

I recently bought a rockwell horizontal mill. The back gears for the spindle are totally enclosed in a very tall cavity...
1 comments posted 22yrs
posted by cas
1 comments posted 22yrs posted by cas

Central A/C Problem

Hope you guys can help. My A/C system has what actually may be 2 problems. Last month, I started to notice water (conde...
3 comments posted 22yrs
posted by jdellafera1
3 comments posted 22yrs posted by jdellafera1